Washing Machine Leaking

A leaking washing machine is the one fault not to leave till the weekend. Water escapes from a split door seal, a perished hose, an overflowing detergent drawer or an element cracked by limescale — and in a Dublin apartment it can reach the ceiling of the flat below within one cycle. Stop the machine and turn off the supply.

Where the water shows up tells you where it is coming from. Water at the front, under the door, points at the door seal or the detergent drawer. Water at the back points at the inlet or drain hoses and their connections. Water spreading from underneath the machine points inside: a split internal hose, the pump housing, or the heating element seal. Work through the location first and the list of causes gets short very quickly.

The usual sources of a leak

Door seal (gasket)

The grey rubber bellows seal is the number one leak source on a front loader. It perishes, tears at the fold, or gets cut by a coin or zip left in a pocket. Mould and germs build up in the folds where soap residue and dirty water sit, and a seal that smells is often a seal that is starting to split. A small drip at the bottom of the door, worst on fuller loads, is the classic sign.

Hoses and connections

The fill hose and its washers harden with age; the drain hose can chafe through where it rubs at the back of the machine or split at the pump end. Check the connections at the tap and at the machine — a slow weep there often only shows under pressure during a fill.

Detergent drawer overflow

Too much detergent, or a drawer and housing crusted with dried soap residue, diverts water down the front of the machine. If the leak is front-left and only happens in the first minutes of the cycle, clean the drawer and its housing jets before suspecting anything expensive. Blocked drawer outlets are common in hard-water homes, where scale narrows them further.

Element and internal splits

In hard-water areas, limescale builds on the heating element until it distorts and splits its seal — or the tub itself weeps at the element port. Water then appears underneath, mid-cycle, when the water is hot. That overlaps with washing machine not heating: an element leaking and an element failing often arrive together.

What to do right now

  • Pause the machine. Turn off the cold water supply at the stopcock or the machine's isolation tap, and switch off at the socket.
  • Mop up and pull the machine's plug — water and a live appliance do not mix. If water has reached sockets or the fuse board, do not touch them; see washing machine tripping the electrics.
  • Photograph where the water appears: front, back or underneath, and at what point in the cycle.
  • In an apartment, tell the neighbour below and your management company straight away — early notice limits the damage claim.

Apartment living makes this urgent in Dublin

Apartments are 27% of Dublin households, and in a flat your leak is somebody else's ceiling. A bowl of water per cycle becomes a management-company dispute and a repair bill for two homes if it runs for a week. Terraced houses, 33.4% of the stock, usually have the machine on a solid ground floor, which buys time — but laminate and timber floors still swell within days. If you rent, note that under the Housing (Standards for Rented Houses) Regulations 2019, Regulation 7, your landlord must provide the washing machine and keep it in good working order — a leaking machine is the landlord's repair, unless the damage came from misuse. Our Dublin repair team can deal with landlords and letting agents directly if that helps.

The water in your area matters

Element and seal leaks are far more common on hard supplies: homes normally supplied by Leixlip — Swords, Lucan, Finglas — get water around 200 mg/L, and Bog of the Ring areas such as Balbriggan, Rush and Skerries around 336 mg/L, which is very hard. On the soft Ballymore Eustace supply in South Dublin, around 50 mg/L, leaks are more often simple perished rubber. Never assume all Dublin water is the same; the supply decides which parts fail.

What a leak repair typically costs in Dublin

Typical Dublin ranges, checked November 2026. Fixed price confirmed after diagnosis, before work; call-out fee stated when booking.

  • Blocked filter/pump clear or drawer and hose attention: covered by the €79 call-out
  • Door seal / gasket replacement: €149–€229
  • Heating element replacement: €179–€249
  • Drain pump replacement: €149–€199

Full pricing is on our repair costs page.

When to call us

If water is coming from underneath the machine, if the seal is visibly split, or if the leak has reached electrics, call Dublin Washing Machine & Fridge Repair on 645 465-6305 today. Tell us where the water appears and we will bring the likely seal, hose or element with us. Every repair carries a guarantee in writing.

Related pages

Questions, answered straight

Short answers for the first few minutes. The team can cover the rest.

Still have a question?

Describe what you are seeing and we will point you to the right next step.

645 465-6305

Most likely the door seal: a tear in the fold, a cut from a sharp object in a pocket, or perished rubber. It can also be the detergent drawer overflowing at the front-left. A door seal replacement is typically €149–€229 in Dublin.

Not safely, and not in a flat. A small leak is a failing part, not a stable one, and it can reach the flat below or your electrics without warning. Turn off the water supply to the machine between uses at most, and book the repair.

Under Regulation 7 of the Housing (Standards for Rented Houses) Regulations 2019, the landlord must provide the machine and keep it in good working order, so an age-related leak is the landlord's repair. The exceptions are a machine you own yourself and damage caused by misuse.

Leaks depend on load size, water level and temperature. Seal tears open under a full drum, drawer overflows happen at the fill stage, and element-seal leaks appear when the water heats and expands. Note which stage of the cycle leaks — it pinpoints the part.

Need a washing machine engineer in Dublin today?

645 465-6305

Tell us the brand, the fault or the error code and your Eircode. You get a likely range on the phone, a fixed price at the machine, and no work without your say-so.

Call now645 465-6305